180 SI-Ethernet User Guide
Issue: 1
8.3 CTScope
CTScope is a software application which provides commonly used oscilloscope
features to monitor drive parameters.
Features include:
• Four channels
• Triggers
• Start/Stop at absolute time
• Start/Stop on value (rising/falling edge)
• Channels can capture parameter values from different nodes
• Scaling & offset per channel
• Cursors to aid measurement
• Zoom facility
• Scroll/Panning facility
• Save/load scope configurations with or without data
• Print facility
CTScope was originally developed for use with Unidrive SP, some limitations exist
when used with Unidrive M, these limitations include:
• Unidrive M parameter database not supported
• No access to option module parameters (except SI-Applications Plus)
• Only parameters 99 or less can be directly scoped (Parameters with a number
of greater than 99 can be mapped to menu 0 and the menu 0 parameter then
scoped.
See knowledgebase doc UNIM004 for more information)
8.3.1 Configuration
All the appropriate configuration settings are displayed on the main screen. (CT-TCP/IP
must be selected in the Communication Settings).
8.4 SyPTPro
SyPTPro is a complete integrated development suite for distributed drive applications.
SyPTPro allows user programs to be developed for multiple nodes in DPL, ladder and
function block programming languages. DPL (Drive Programming Language) is a high
level language as easy to use as BASIC but optimised for drive applications. SyPTPro
also allows user programs to be downloaded to nodes and the runtime operation of the
programs to be monitored.
To use SyPTPro over Ethernet requires a version that provides Ethernet support,
SyPTPro V02.01.00 or later includes support for TCP/IP.
For more information on using SyPTPro please refer to the online help supplied.
SyPTPro can only be used to program a SI-Applications Plus option module and not an
onboard drive program or a MCi200/MCi210 Machine Controller module.
SyPTPro is only supported on the onboard Ethernet.
To Next Page
Loading...
