Emerson UNIDRIVE M600 - Page 53

SI-Ethernet User Guide 53
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
6.1.4 Menu 10 – Easy Mode Cyclic Data
The menus specified here allow up to 3 transmit and 3 receive cyclic links to be
configured. Each receive link can have its own timeout configured with an additional
custom action.
For greater control advanced cyclic links can be configured using the cyclic link editor
within Machine Control Studio.
Base link parameters
* Required if Type set to “unicast”
This parameter is used to enable or disable the Easy Mode protocol interface.
This parameter is used to perform a warm reset of the protocol interface. When set and
the protocol has reset, the parameter will be reset to zero (Off).
Link Profile Link No.
Src/Dest
Par
Par Count Type IP Address Rate
Tx1 S.10.010 S.10.011 S.10.012 S.10.013 S.10.14 S.10.015* S.10.016
Tx2 S.10.020 S.10.021 S.10.022 S.10.023 S.10.24 S.10.025* S.10.026
Tx3 S.10.030 S.10.031 S.10.032 S.10.033 S.10.34 S.10.035* S.10.036
Rx1 S.10.040 S.10.041 S.10.042 S.10.043 S.10.044 n/a n/a
Rx2 S.10.050 S.10.051 S.10.052 S.10.053 S.10.054 n/a n/a
Rx3 S.10.060 S.10.061 S.10.062 S.10.063 S.10.064 n/a n/a
S.10.001 Enable
Minimum 0 Maximum 1
Default 1 Units
Type 1 Bit User Save Update Rate Background read
Display Format None Decimal Places 0
Coding RW, BU
S.10.002 Reset
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate Background read
Display Format None Decimal Places 0
Coding RW, NC