Unidrive M700/M701 / Unidrive HS70/HS71 Control Getting Started Guide 15
Issue Number: 2
Safety information Introduction Control connections
Getting started
Basic parameters
(Menu 0)
Running the motor Further information
4. Select 'Save parameters in drive' to perform a parameter save.
The drive is now ready to run.
Action Detail
Motor Setup
Unidrive M Connect contains a database for induction motors and permanent magnet motors.
Provision is also made to enter motor nameplate data.
The next section describes the use of the motor database for a Leroy Somer LSRPM motor
used in RFC-S Sensorless mode.
Motor Feedback
Setup
This only needs to be performed in RFC-A (with feedback) mode
Set Pr 03.024 = Feedback (0)
Enter:
• Encoder power supply in Pr. 03.036 = 5 V (0), 8 V (1) or 15 V (2). *
If output voltage from the encoder is >5 V, then the termination resistors must be
disabled Pr 03.039 to 0. *
• Drive encoder Lines Per Revolution (LPR) in Pr 03.034 (set according to encoder) *
• Drive encoder termination resistor setting in Pr 03.039: *
0 = A-A\, B-B\ termination resistors disabled
1 = A-A\, B-B\, termination resistors enabled
* mm is dependant on the slot into which the SI-Encoder module is installed (15 =Slot 1, 16 =
Slot 2, 17 = Slot 3).
Analog I/O
The motor thermistor can be selected in Pr 07.015. Refer to the parameter help for Pr 07.015
for further information.
Ramps Setup
Enter the required Acceleration rate and Deceleration rate
Note: If a braking resistor is installed, set 'Ramp mode' to 'Fast'. Also ensure Pr 10.030 and
Pr 10.031 and Pr 10.061 are set correctly, otherwise premature 'Brake R Too Hot' trips may
be seen).
Autotune
Not required when using data from the motor database for a Leroy Somer LSRPM motor used
in RFC-S Sensorless mode.
Setting the encoder voltage supply too high for the encoder could result in
damage to the feedback device.
Unidrive M700_M701 Getting Started Guide English iss7.book Page 15 Friday, December 12, 2014 1:14 PM
To Next Page
Loading...
