13
1
10
2
11
3
12
4
13
5
14
6
15
7
16
8
17
9
18
0,5Nm
aa
6 mm / 0.236 inch
Wire Size:
18 AWG / 1 mm²
Solid /Stranded
18 screws terminal
M3
Empty terminals
Torque 0.5 Nm
Screw driver
You must ensure that the device is correctly configured for your application.
Incorrect configuration could result in damage to the process being controlled,
and/or personal injury. It is your responsibility, as the installer, to ensure that
the configuration is correct.
Parameters of the device has factory default values. These parameters must be
set according to the system’s needs.
Only qualified personnel and technicians should work on this equipment. This
equipment contains internal circuits with voltage dangerous to human life.
There is severe danger for human life in the case of unauthorized intervention.
Be sure to use the rated power supply voltage to protect the unit against
damage and to prevent failure.
Keep the power off until all of the wiring is completed so that electric shock and
trouble with the unit can be prevented.
3.Electrical Wiring
c
c
c
c
3.1 Terminal Layout and Connection Instructions
To Next Page
Loading...
