EMM Labs DA2i - Safety Instructions

Safety Instructions
Prior to Installing your new EMM Labs product please read the following safety
instructions:
• Read and follow all instructions
• Keep these instructions
• Do not use or install product near any sources of water, rain and/or moisture
• Clean using only a dry cloth
• Install only in accordance with the manufacturer’s instructions
• Refer all servicing to approved service personnel
• Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including ampliers) that produce heat
• Do not install product outdoors or in direct sunlight
• Leave at least 10cm or 4 inches around product to ensure proper ventilation
• Do not place product near strong electrical or magnetic radiation/emissions
or near a power amplier
is EMM Labs product must be connected to a mains socket outlet with a protective
earthing connection (grounding pin). All EMM Labs products must be connected to a
mains socket or outlet, with a protective earthing connection (grounding pin).
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPARATUS TO WATER OR MOISTURE.
EEC: is product has been designed and tested to comply with the
limits set out in EN55032:2022, EN55035:2018, and EN 62368-1:2014
(electrical safety).
© 2024 EMM Labs, All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
004
Safety Instructions
DA2i STEREO D/A CONVERTER OWNER’S MANUAL