How to use the pram body
Adjusting the Backrest
• Lift the backrest (3) and rest it against the metal supports (4)
Fitting the pram body on the chassis
• The brake should be engaged
• Push the Easy Fix lock (1) until it “clicks into” place on both sides.
WARNING
• Check before use that the pram body is securely in place
Detaching the pram body from the chassis
• The vehicle brake should be engaged
• Push the Easy Fix grips (2) on both sides of the pram body and
release the pram body part straight up from the chassis.
IMPORTANT
• You must release the pram body part before you fold the chassis
WARNING
• Never attach/detach pram body with a child inside.
Adjusting the Hood
• Adjust the hood by gently pulling the front of the hood back and
forth to the desired position.
Do not adjust the hood with the apron attached
IMPORTANT
• Never carry the pram body by the hood
• Never carry the pram body when it is assembled onto the chassis
Adjusting the ventilation system (not Smart)
• Adjust the airow to maximum by pulling the lever (5) out-
wards away from the pram body.
• Push the lever inwards to close the ventilation holes.
IMPORTANT
• On the bottom of the pram body there are xing points for a
separate harness that complies with BS 6684.
Cradle function (not on the Smart)
• The pram body can be used as a cradle (6) on indoor, horizontal
and even surfaces.
WARNING
• Never place pram body near stairs, on top of tables or in other
areas where it might fall down.
• Never use pram body as a cradle outdoors or on uneven surfaces.
• Never use the pram body as a permanent bed for your child.
English
To Next Page
Loading...
