3
5
32
Manual Nitro City v. 1.8
5
6
7
8
6
7
9
Engaging the parking device
• Engage the parking device by pushing it down with your foot.
• Disengage the parking device by pulling up
WARNING!
• Never leave the vehicle without rst engaging the parking device.
• The brake should always be engaged when you lift your child in
and out of the stroller/pram.
• Avoid uphill or downhill parking.
• Make sure that the cogs are attached properly on both back
wheels.
• Make sure that the brake pin engages into the cogs when the ve-
hicle is parked.
Assembly and usage of the chassis
Make sure children are clear of any moving parts if you adjust the
stroller, otherwise they may be injured.
Folding the chassis
• Start by making sure that the brake is engaged.
• Ensure the front wheels ar in the swivel position by pulling the lock-
ing ring up (see next page picture 13)
• Fold the chassis by pulling the two main locking devices, one on
each side, upwards.
• Lift the secondary locking device (5) and fold the handle forward.
• If you need to make more space you can remove the wheels by
pressing in the hub cap’s release mechanism and pulling the wheel
off the axle.
• Wipe off any dirt or grease from the axles before you replace the
wheels.
• The tray is already tted on delivery but it can be removed for
washing. Remove the wooden plate before washing.
How to adjust the height of the handle
• Adjust the height by pressing the grey buttons on the inside of the
handle (6). Keep the buttons pressed in while you adjust to the
required position (7)
Adjusting the hood
• Adjust the hood by gently pulling the front backwards and forwards
until it reaches the desired position.
• Some stroller models are equipped with a mosquito net. The
mosquito net can be pulled over the footrest and attached with the
plastic hooks.
Important!
• Never lift the stroller by holding on to the hood
• Never lift the top part when it is assembled on the chassis
To Next Page
Loading...
