Emmaljunga Nitro City - City Carrycot Assembly; Pram Body and Mattress Setup; Attaching Hood and Apron

1
2
2
1
3
4
4
3
5
5
6
7
8
8
7
34
Manual Nitro City v. 1.8
1
Assembly of pram body
• Remove plastic covers from mattress, fabrics and discard. Slide the
two metal support brackets (1) onto the base of the pram body.
• The base is made of wood.
WARNING
• Risk of suffocation. Do not let your children play with the plastic
packaging.
• Make sure that the metal support bars are attached so that the
pram stability and safety will not be jeopardised.
• Press the hood fabric onto the plastic holder (5), on each side.
Press the velcro (6) onto the pram body.
• Press the apron onto the hood (7) and onto the plastic holder (8) on
each side.
IMPORTANT
• The hood cannot be pushed back when the apron is snapped onto
the hood without releasing the press studs (8)
• Insert the mattress (4).
• The exclusive mattress consists of a combination of bre lling
and polyeter lling. Make sure that you place the mattress with the
rmer polyeter lling facing downwards in the carrycot.
WARNING
• The depth from the top of the mattress together with other bed
accessories to the carrycot upper part (3) must be at least 150mm.
• Do not add a mattress thicker than 45 mm.
• Attach the hood to the pram body by pushing the plastic leg of the
hood into the plastic holders on the pram body. Make sure they
snap into place.
Assembly and usage of the
City Carrycot (Accessory to Nitro City)