English
33
Manual Nitro City v. 1.8
8
10
9
12
10
10
11
11
13
12
14
13
14
Assembly and usage of the chassis
Make sure children are clear of any moving parts if you adjust the
stroller, otherwise they may be injured.
Adjusting the footrest
• The footrest can be adjusted into two positions. Adjust the footrest
to the down position by releasing the lock on the side of the footrest
and pulling the footrest horizontally (8) and downwards.
• Make sure that the footrest is locked into desired position before
usage.
• The footrest is adjusted by pulling the footrest upwards and then
pushing it horizontally back towards the pram.
• The footrest pad is reversible.
WARNING!
Never let your child/children stand on the footrest
Adjust the 5-point harness
• Bring crutch strap (9) forward between the child’s legs and up
toward front of waist. Insert the waist straps (10) into the harness
buckle until they “click” in place. Make sure waist straps are faste-
ned.
• Adjust all straps, using the sliders (11).
• To release shoulder and waist straps, press the buttons (12) in the
centre of the harness buckle.
• Attachment points are provided at the ends of each waist strap for a
separate harness complying with BS 6684
WARNING!
• Always use the harness when the child is placed in the vehicle.
Make sure that all buckles are tted into position and that the har-
ness is attached to the vehicle’s D-rings.
Picture 13: The front wheel can be xed or swivel 360 degrees.
• The wheels are xed by pressing the locking ring (14) down.
• The wheels can rotate freely 360 degrees by pulling the locking ring
up.
Picture 14: Adjust the angle of the City carrycot
• Remove your child from the pram before adjusting the angle.
• Adjust the angle by pulling the grey tab outwards and twist the
knob until the grey button locks into the desired position: 1, 2 or 3.
Repeat on the other side of the chassis - make sure the knobs are
in the same positions on both sides of the chassis.
IMPORTANT
• Adjust the angle when the chassis is folded to avoid unneccesary
wearing of the mechanism.
WARNING
• The mechanism must be in the same position on both sides of the
chassis to avoid uneven strain and possible damage to the chassis.
• Make sure the grey button has locked into position in order for the
mechanism to function properly.
Adjusting the backrest
• The seat backrest is adjustable by moving the seat adjustment
lever (13) located at the bottom behind the seat, toward backrest.
WARNING!
• Once in desired position, push on backrest to ensure a locked
position.
To Next Page
Loading...
