How to fix emmeti EH1218DC that does not start re-operation immediately?
After stopping, the emmeti Heat Pump will not restart immediately for approximately 3 minutes. This is to protect the system.
General| Heating Capacity | 12 kW |
|---|---|
| EER Cooling | 3.5 |
| Refrigerant | R410A |
| Type | Air to Water |
| Power Supply | 220-240V, 50Hz |
Explains circulator performance characteristics based on flow rate and head for different speed levels.
Defines the operational limits for heating and cooling based on air and water temperatures.
Safety information, first aid, firefighting measures, and exposure controls for refrigerant R32.
General warnings, prohibitions, symbol meanings, and safety instructions for unit operation.
Lists prohibited installation practices and important warnings for qualified personnel.
Details on connecting the hydraulic system, including diagrams and recommendations for a safe setup.
Explains the unit's built-in anti-freeze function and the necessary settings for operation.
Step-by-step guide for filling the hydraulic circuit and removing air to ensure proper circulation.
Information on electrical connections, power supply requirements, and safety precautions.
Detailed instructions on connecting wires to the terminal block, including polarity and tightening torques.
Details how to access and modify parameters within the "Set" menu for system configuration.
Comprehensive list of service parameters, including temperatures and analogue inputs.
Details on signals received from the Febos Crono Master system related to ambient conditions.
Explains the operational status and activation of heat pump functions and outputs.
Information on activating Set Point 2 and its associated climate curve for temperature control.
Parameters for adjusting compressor frequency based on water temperature settings.
Parameters for configuring the domestic hot water production, including timings and temperatures.
Instructions for turning the heat pump on and off using the Febos-Crono Master system.
How to select heating or cooling mode using the Febos-Crono system based on external commands.
Setting target water temperatures and adjusting them via climate curves for heating and cooling.
How the compressor modulation works across different steps and signals based on operating conditions.
Instructions for setting up domestic hot water heating using sensors and parameters.
How the heat pump operates in parallel with an additional generator when thermal load is high.
How the heat pump operates in alternate mode with a secondary generator based on external temperature.
Information on the unit's frost protection functions and how to manage them via SMART-MT.
Configuration and operation modes for the dehumidifier function based on various parameters.
How to view active alarms on the SMART-MT display and access the alarm menu.
Common issues and their potential causes or checks for the unit, including storm or interference effects.
List of alarm codes displayed on the SMART-MT and their corresponding solutions.
Error codes displayed on the PCB and their troubleshooting steps, including electrical supply issues.
Final PCB error codes for defrost heater, air circulation, gas leakage, and expansion vessel.
Wiring diagram for the EH0618DC model, showing electrical connections to the PCB and components.
To Next Page
