Windshield
1. Locate the 5 pieces needed for this windshield. First find the small gold clip(as shown in
figure 1-13. Install it as shown in figure 1-13.
figure 1-13
2. Place the windshield correctly.
3. Use the five screws and tighten them lightly.
Final Check
1. Check all nuts screws and bolts including ones not mentioned in the set up, for tightness and
fit before riding.
2. Dispose of packaging thoughtfully and responsibly. Recycle cardboard.
3. Ensure charger is functioning both connected to bicycle and directly to the battery pack when
removed from bicycle.
4. When connected to the bicycle, turn ignition on , charging voltage should be around
40-44volts on the meter. Test by connecting and observing charging light on the charger.
To Previous Page
Loading...
