P.A.S. Control and display
Display Interface!
After switching on the e-bike system, the display shows current speed and total
distance except, battery indicator and assistance level
◆ To change the indicated information, press the
MODE button to show in turn as follows:
Current Speed (Km/h) → Trip Distance (Km) Trip Time (Hour)\
→ Max. Speed (Km/h) → Avg. Speed (Km/h)
→ Motor-output (W) →Current Speed (Km/h).
◆ Switching PAS Off: There is a preset setting which allows your
bike to cruise at a steady speed of 3.7 MPH (6Km/h), the letter "P"
is shown at the screen. To engage this cruise control feature press
and hold the "-" button for a few seconds until the letter "P" shows
on the screen. To disengage this function press the brakes.
Manual Clearance Function!
Among of all functions, Trip Distance, Trip Time, Max. Speed and Avg. Speed, can only be cleared manually.!
If the above functions need to be cleared, After switching on the E-bike system and parking the E-bike, please to hold the
MODE button and the DOWN button for 2 s, the above functions can be cleared at the same time.
Press the power button (M button) on the handlebar controls located near the left grip to tum it on.!
You can adjust the pedal assist power level to have more power by hitting the [+] button (right button) and can move to a lower level
power by hitting the [-] button (left button).
When not riding your bike, you can tum off the meter by holding down the power button (M button) for several seconds.
8
To Next Page
Loading...
