CLEANING AND MAINTENANCE
NOTE: To extend the life of your oven, it must be cleaned frequently, keeping in mind that
The enameled or stainless steel parts should be washed with lukewarm water without using any abrasive
powders or corrosive substances which could ruin them; Stainless steel could get stained. If these stains are
difficult to remove, use special products available on the market. After cleaning, it is advisable to rinse
thoroughly and dry.
The inside of the oven should preferably be cleaned immediately after use, when it is still warm, with hot water
and soap; The soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive detergents
(for example cleaning powders, etc) and abrasive sponges for dishes or acids (such as lime scale –remover,
etc…) as these could damage the enamel. If the grease spots and dirt are particularly tough to remove, use a
special product for oven cleaning, following the instructions provided on the packet.
If you use your oven for an extended period of time, condensation may form, Dry it using a soft cloth.
There is a rubber seal surrounding the oven opening which guarantees its perfect functioning, Check the
condition of this seal on a regular basis. If necessary, clean it and avoid using abrasive products or objects to do
so. Should it become damaged, please contacts you’re nearest After-sales Service Center. We recommend you
avoid using the oven until it has been repaired.
Never line the oven bottom with aluminum foil, as the consequent accumulation of heat could compromise the
cooking and even damage the enamel.
Do not store flammable material in the oven.
REMOVE THE OVEN DOOR
Before cleaning your oven, or performing maintenance, disconnect it from
the power supply.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
oven door glass since they can scratch the surface, which may result in
shattering of the glass.
For a more thorough clean, you can remove the oven door. Proceed as follows:
1.Open the door fully;
2.Lift up and turn the small levers situated on the two hinges;
3.Grip the door on the two external sides，shut it slowly but not
Completely;
4.Pull the door towards you, pulling it out of its seat;
Reassemble the door by following the above procedures backwards.
To Next Page
Loading...
Need help?
General
