Weight and Dimensions are approximate. Because we continually strive to improve our products
we may change specifications and designs without prior notice.
Installation
Selection of installation equipment
• Cut out the work surface according to the sizes shown in the drawing.
• For the purpose of installation and use, a minimum of 1.97in space shall be
preserved around the hole.
• Be sure the thickness of the work surface is at least 1.18in. Please select
heat-resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate. As shown below:
•
Warning: The work surface material must use the impregnated wood or other
insulation material.
To Next Page
Loading...
