EMS MEGAPULSE SENIOR 265 User Manual

OM265EN issue 16
21
Operating Instructions
Power on sequence and general information
Connect the mains cable to the IEC socket on the rear of the unit
and to a suitable power outlet. Switch on the unit using the mains
switch adjacent to the IEC socket. The standby indicator on the top
panel will light amber. Pressing the ON button will cause the
indicator to change to green and the display to illuminate and show
the EMS company logo and name, the model name and number, the
firmware version and the serial number.
Fig.8 Start screen
After approximately 3 seconds, the unit will give a short beep and the
display will show the home screen.
Standard key functions
Throughout the operation of the Megapulse Senior 265, all functions
are accessed and controlled using the touch screen.
The rotary control is only used to initiate or end a treatment and
increase or decrease the RF output.
During a treatment the touch buttons are all inactive.

EMS MEGAPULSE SENIOR 265 Specifications

General

Brand	EMS
Model	MEGAPULSE SENIOR 265
Category	Medical Equipment
Language	English