What to do if EMS Medical Equipment shows “Over temperature”?
If the EMS Medical Equipment displays an “Over temperature” message, leave the unit switched on and allow it to cool for 15 minutes before switching it off and restarting.
What to do if EMS MEGAPULSE SENIOR 265 Medical Equipment shows “Treatment” but no warmth?
If the EMS Medical Equipment shows “Treatment” but the patient feels no warmth and the fluorescent indicator is off, verify that the pulse width and frequency settings are producing a thermal output (more than 20W average power). Also, ensure that the correct electrodes have been selected, that the electrodes are securely connected, and that the power output level is greater than 10%.
General| Brand | EMS |
|---|---|
| Model | MEGAPULSE SENIOR 265 |
| Category | Medical Equipment |
| Language | English |
Lists changes made to the manual over different issues.
Explains pulsed shortwave therapy and its benefits compared to continuous wave.
Lists conditions for which the EMS265 can be used, including acute and chronic soft tissue injuries.
Discusses potential electromagnetic interference with electronic devices and suitability for different environments.
Warns against stacking or placing equipment adjacent to the unit to prevent improper operation.
Provides instructions on how to disinfect and clean electrodes, and clean the unit.
Lists conditions and situations where the device should not be used, such as pregnancy and tumours.
Lists recommended electrodes and cables for the Megapulse Senior 265.
Identifies and explains the controls and markings on the Megapulse Senior 265 control panel.
Specifies temperature, humidity, and pressure limits for transporting and storing the unit.
Specifies temperature, humidity, and pressure limits for operating the unit.
Defines essential performance and lists functions whose degradation could cause a hazardous situation.
Outlines the power-on sequence and general operation of the unit.
Describes the home screen interface and navigation options.
Explains how to select and use pre-set clinical treatment protocols.
Details how to manually configure treatment parameters like mode, pulse width, and frequency.
Explains how to save, recall, and manage custom treatment programs.
Describes the feature for adding notes to user programs.
Overview of the settings menu for system adjustments.
Explains how to adjust the screen brightness.
Details how to adjust the volume and sound settings.
Explains how to select the user interface language.
Describes how to set the system's time and date.
Explains how to access the help function, which displays the manual.
Explains the maintenance mode for service engineers.
Details the tuning process for Monopulse applicators.
Explains how to view unit information like serial number and firmware version.
Provides step-by-step instructions for applying treatment with the Monopulse applicator.
Explains power limitations for continuous mode to prevent tissue overheating during extended treatments.
Instructions for using rigid capacitive electrodes with the Megapulse Senior 265.
Instructions for using flexible rubber capacitive electrodes.
Describes the safe method to end a treatment session.
Instructions for cleaning, calibration, and service requirements for the unit.
Provides contact information for EMS Physio Ltd. for support and service.
Lists common symptoms and their corresponding actions for resolving issues.
Illustrates the waveform characteristics of pulsed output.
Details the electromagnetic compatibility (EMC) test standards and levels for the device.
To Next Page
