OM265EN issue 16
23
‘Protocol treatments’ brings up a list of clinical conditions, which
can be stepped through using the up and down arrow buttons.
Touching the anatomical figures will limit the displayed list to those
relevant to the selected body area.
Fig. 10 Protocol treatments screen
Touching the highlighted condition will take you to a page with the
parameters necessary to treat that condition already set. Most are
‘greyed out’ and can’t be altered – only the electrode type can be
changed to suit that being used, and treatment is initiated and power
increased to the desired level by operating the rotary control.
When treatment is started, a rotating tuning icon will appear for a few
seconds, then a flashing treatment icon will appear showing that the
unit has tuned and power is being produced at the chosen level.
When in the selected treatment page, but not during an active
treatment, touching the ‘Protocol treatments’ button will return you to
the Protocols list.
Touching the ‘Notes’ button will take you to a QWERTY keypad that
can be used to write any information pertinent to that treatment (or
patient), which can then be stored using the ‘Save’ button (see Fig.
13 on page 27).
Each treatment has its own separate notes file.
To Next Page
Loading...
Need help?
General
