SYS5INST ISS.3 2000
13
8.0 Installation Advice.
• Ensure that you have all equipment required to complete the installation of
System 5000.
• Ensure that the correct fixings and fasteners are used for all installation work.
• Observe ESD precautions.
• Familiarise yourself with the system details and layout, before commencing any
installation activity. Any anomalies must be addressed with the Surveyor, End
User or the equipment supplier.
• Ensure that the Control Panel back box is clean and free of swarf prior to fitting the
internal assemblies.
• Ensure that the power supply to the Control Panel has been made by way of a fused
spur (fuse rated at 3 amp) and that a red circuit breaker is fitted.
• Do not replace the Callpoint dummy breakglass, with the final glass version, until
the system is ready for “handover”. This is to avoid the possibility of damage
occurring during installation work.
• Wherever practical, fix detectors so that the red LED faces the main entrance to the
room.
• Should it be necessary to remove the two aerials fitted to the Control Panel, ensure
that when refitted, the coloured band on the aerial corresponds with the coloured
disk on the BNC connector on the panel.
• Ensure that the 240V AC mains supply is fused and unswitched.
To Next Page
Loading...
Need help?
General
