SYS5INST ISS.3 2000
8
5.4.4 Remove cellophane wrapping and Insert the 3 x AA cells and 3 x C cells
batteries supplied with device, by and inserting as shown below, ensure the supplied
battery ribbon is wrapped around the first AA cell to enable easy removal of the
batteries at a future date.
Figure 5
Note : observe correct battery polarity as shown above.
5.4.5. Connect the power lead from the backbox to the front unit. Locate the
Transmitter section into the back box, securing in place by the two assembly screws.
To Next Page
Loading...
