Need help?Do you have a question about the Emtek EMTouch and is the answer not in the manual?
Explains how to determine the door's handing (LH/RH) for correct installation.
Outlines the required bore hole sizes and depths for the door and jamb.
Details the process of fastening the strike plate to the door jamb using wood screws.
Covers fitting the latch mechanism into the door and adjusting the backset.
Instructions for removing screws from the inside trim plate before mounting.
Steps for installing the outside trim plate assembly through the door bore hole.
Guides on positioning the cam link and feeding the wire harness into the inside chassis.
Details on fastening the inside trim plate using machine screws and checking alignment.
Explains how to unlock, use the passage feature, and lock the Emtek EMTouch lock.
Covers changing programming codes, adding/deleting user codes, and managing settings.
Describes LED/beep signals for lock status and the procedure to restore factory defaults.
General| Keypad | Yes |
|---|---|
| Power Source | 4 AA Batteries |
| Compatibility | Standard doors |
| Latch Type | Deadbolt |
| Handing | Reversible |
| Type | Electronic Keypad Lock |
| Material | Brass |
| Finish | Various finishes available |
| Backset | 2-3/8" or 2-3/4" |
| Door Thickness | 1-3/8" to 2" |
| Keyway | Schlage C |
| Warranty | Limited Lifetime Mechanical; 1 Year Electronics |
To Next Page
