ENCLO EC18010 - Step 2: Assemble the Panel

www.encloscreens.com
5
ASSEMBLY INSTRUCTIONS EC18010
STEP 2: ASSEMBLE THE PANEL
STEP 2.1 STEP 2.2
C
D
1. Slide (2) Rails (C) into the routed holes in the
Left Post (D).
2. Slide (11) Slats (B) into the angled slots in
the left post.
1. Slide (1) Right Post (E) over the opposite
ends of the slats and rails. Ensure the rails
and slats are tight to the back of both posts
and that the unit is square before driving in
screws.
2. Drive (8) total ¾" Self-Drilling Stainless Steel
Screw (G) into the pre-drilled holes in the
posts.
B
2
1
2
1
E
G