Do you have a question about the Encore ENH924-AUT and is the answer not in the manual?
standard | IEEE802.3, 10BASE-T |
---|---|
interface | RJ-45 x 24 NWay switching ports |
network data rate | Auto-negotiation (10Mbps, 100Mbps) |
transmission mode | Auto-negotiation (Full-duplex, Half-duplex) |
system buffer memory | 768K byte |
MAC address table | 4K entries |
filtering/forwarding rate | 10Mbps: 14, 880pps/14, 880pps, 100Mbps: 148, 800pps/148, 800pps |
operating temperature | 0°C ~ 50°C (32°F ~ 122°F) |
---|---|
operating humidity | 10% - 90% |
emission | FCC Class A, CE |
power supply | 100~240VAC, 50~60Hz |
---|
Provides a high-performance Fast Ethernet switching hub with 24 ports for auto-negotiation.
Lists key features of the switch, including compliance, port capabilities, and auto-negotiation.
Describes the front panel of the switching hub and its diagnostic LEDs.
Explains the system LED indicators on the front panel for device status.
Details the port LED indicators, including speed and link/activity status.
Illustrates the rear panel of the switching hub, including power input and switch.
Explains how to connect the power cord to the switching hub for operation.
Guides users on how to install the switching hub without software configuration.
Provides instructions for placing the hub on a desk, connecting cables, and ensuring proper airflow.
Details the process of mounting the switching hub in a standard 19-inch equipment rack.
Explains how to connect network cables to the switching hub for network connectivity.
Describes connecting individual stations to the hub using twisted-pair cables.
Explains how to connect multiple switches using straight cables due to auto-crossover detection.
Explains how the hub uses a MAC address table for packet filtering and forwarding.
Details the process of filtering and forwarding packets based on destination addresses.
Describes the store-and-forward methodology for efficient and stable network transmission.