8
3. Installing And Using 24 Port NWay Switch
3.1 Installing The 24 Port NWay Switch
The hub does not require software configuration. Users can immediately use any of
the features of this product simply by attaching the cables and turning the power on.
3.1.1 Desktop Installation
Locate the switching hub on the desktop and place the hub on a clean, flat desk or
table close to a power outlet. Plug in all network connections and the power cord, then
the system is ready.
When deciding where to put the switching hub, you must ensure:
It is accessible and cables can be connected easily.
Cabling is away from:
Sources of electrical noise such as radios, transmitters and broadband amplifiers
power lines and fluorescent lighting fixtures.
Water or moisture can not enter the unit.
Air flow around the unit and through the vents in the side of the case is not
restricted (company recommend that you provide a minimum of 25mm inch
clearance)
To prolong the operational life of your units:
Never stack units more than eight high if freestanding.
Do not place objects on top of any unit or stack
Do not obstruct any vents at the sides of the case
To Next Page
Loading...
Need help?
Network Specifications
Power
