Signal Strength of Percentage: Shows the wireless signal strength of the
connection between the Wireless LAN USB 2.0 Adapter with the Access Point.
TX/RX: Shows the statistics of data transfer, and the calculation is based on the
number of packets transmitted and received. It also shows the link quality of the
Wireless LAN USB 2.0 Adapter with the Access Point when operation under
Infrastructure mode.
Configuration
This screen is where you set the basic wireless settings for the Wireless LAN
USB 2.0 Adapter.
Profile Name: The default name is the same as the SSID of the platform which
you connected and you can change the name you favor ( the key length is limited
1~32 bits).
SSID: Service Set Identifier, which is a unique name shared among all client in a
wireless network. The SSID must be identical for client in the wireless network.
Wireless Mode: There are two modes available for selection
z Infrastructure –to establish wireless communication with the LAN and other
wireless client through the use of Access Points.
z Ad-Hoc – to establish point- to-point wireless communication directly with
other wireless client device.
To Next Page
Loading...
Need help?
General