Encore RAGE ER48FX730VX - Specifications; Model Number; Weight & Dimensions; Engine

16
SPECIFICATIONS
MODEL NUMBER
ER48FX730VX
ER52FX730VX
ER60FX730VX
WEIGHT & DIMENSIONS
48”
52”
60”
Width –
Deflector Up
49”
53”
61”
Width –
Deflector Down
60”
65.5”
73”
Length
74”
74”
74”
Wheelbase
42.5”
45”
45”
Wheel Track –
Front
28.7”
28.7”
28.7”
Wheel Track –
Rear
33”
34.7”
34.7”
Curb Weight
880 lbs
895 lbs
916 lbs
ENGINE
• Kawasaki FX730VX
• See your Engine Owner’s Manual
• RPM: High Idle: 3600
Low Idle: 1550
FUEL SYSTEM
• Capacity: 8 Gal
• Type of Fuel: Regular Unleaded Gasoline
87 Octane or higher
• Fuel Filter: In-line
ELECTRICAL SYSTEM
• Charging System: 12 Volt, 15 Amp @
3600 RPM
• Battery Type: Group U1
• Battery Class: 350 CCA Minimum
• Battery Voltage:12V DC
• Polarity: Neg. Ground
• Fuses: (1) 15A; (1) 20A
TRANSMISSION
Two Parker HTJ Transaxles
• Hydraulic Oil: Synthetic 5W-50
• Speed: 0-10.5 mph Fwd
0-4.5 mph Reverse
CUTTING DECK
• Cutting Width: 48” – 52” – 60”
• Discharge: Side
• Blade Size: 16.25” - 18” – 20.5” (3 ea)
• Deck Drive: Electric Clutch
• Deck: 4mm Welded Steel
• Deck Depth: 5”
• Cutting Height 1.5” to 5”Adjustment:
• Mulching Kit: Optional
TIRES
o Front: 13-5.00-6 – 48”
13-6.5x6 – 52”/60”
o Pressure 12-14 psi (83-97 kPa)
o Rear: 22-10.0 x 10 – 48”
o 22-11.0 x 10 – 52”/60”
o Pressure 15 psi (103 kPa)
TORQUE REQUIREMENTS
BOLT LOCATION
TORQUE
CUTTER HOUSING NUT
90-95 ft/lb
BLADE BOLT
50-60 ft/lb
ENGINE MOUNTING BOLTS
KAWASAKI FS600
30-35 ft/lb
WHEEL LUG NUTS
85-105 ft/lb
WHEEL MOTOR MOUNTING
BOLTS
72-77 ft/lb
CLUTCH RETAINING BOLT
50-55 ft/lb