care and maIntenance
Your ENDLESS POOLS fitness system is manufactured from the
highest quality, most durable materials available. Even so, the fitness
system care and maintenance program you develop will ultimately
determine how long your fitness system, and its individual components,
will last. Regular maintenance and following the advice in this section will
help you to protect your investment.
FILTER MAINTENANCE
At least once a week, check and clean the skimmer trays to ensure
proper filter flow. Remove leaves, foreign matter, and debris. It is
very important to keep your fitness system filter cartridges clean and
free of particles to ensure proper water flow. Clean filters enables the
hydrotherapy system to function properly and allows for more efficient
filter cycles. Depending on how frequently your fitness system is used,
we recommend cleaning the fitness system filter cartridges every four
weeks. If this is not done, the filter may clog and restrict water flow,
which causes improper filtration, poor jet performance and may possibly
freeze.
IMPORTANT: The frequency and duration of use, and the number of
occupants all contribute to determining the appropriate time between
filter cleanings. More use means that more frequent filter cleanings will
be required.
FILTER CARTRIDGE REMOVAL AND
CLEANING INSTRUCTIONS
Place the fitness system in the "Standby" mode, then proceed as
follows:
1. Find the filter grate inside
the fitness system.
2. Pull the filter grate from the
bottom up until it unlocks
from the wall.
IMPORTANT: ONLY
PULL FILTER GRATE UP
SLIGHTLY.
3. Pull filter grate away from
wall and set aside.
4. Pull skimmer tray away from
wall, remove and clean.
5. To remove the filter, turn
using the handle in the
center of the filter
counter-clockwise.
6. Pull filter up, then angle the top
away from the filter compartment
to pull filter completely out. Each
filter has 4.5 m² of effective filter
area.
7. Repeat steps 4 & 5 to remove
second filter.
Always clean the filter using
a filter degreaser to remove
mineral and oil build-up. Simply
soak the filter in the degreaser (according to the package directions),
then place the filter on a clean surface and spray until clean using a
garden hose. It may be necessary to rotate the filter while spraying to
remove any debris lodged between the filter pleats.
8. Re-insert filter cartridge by reversing steps 5, 6 & 7.
9. Slide skimmer try back into filter compartment reversing step 4.
10. Position filter grate as seen in step 2 & 3, grate should touch wall of
fitness system slightly about black filter equipment compartment
tracks. Slide filter grate down until it stops.
Repeat all of the above steps for the filters on the opposite side
NOTE: Replacement filter cartridges are available from your ENDLESS
POOLS dealer. Refer to the back of this manual to determine the
appropriate size for your fitness system.
Page 23
Care and Maintenance
To Next Page
Loading...
Need help?
General
