EasyManuals Logo

Endless Pools Streamline User Guide

Endless Pools Streamline
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Nature 2 Installation
The Nature 2 purication system will be placed inside of the lter
cartridge. A retention strap has been provided to prevent the Na-
ture 2 (slotted blue cartridge) from falling out of the lter.
Remove the Nature 2 cartridge, handle, and retention strap from
its packaging (Fig. 4). Loop the retention strap around the Nature
2 cartridge handle, making sure the location of the strap is above
the ns on the handle, and interlock the strap end into its locking
mechanism. Cut the strap down to approximately two inches using
a pair of scissors (Fig. 5).
Fig. 4
Fig. 5
Attach the handle to the main body of the Nature 2 cartridge by
aligning the hole at the bottom of the handle to the nipple that’s
attached to the main body of the cartridge (Fig. 6). Make sure there
is a rm connection between the handle and the main body of the
cartridge.
Fig. 6
Next, pull the cylindrical oating cage out of the lter body. Re-
move the lter cartridge from the lter body inside the pool, by
grabbing the top and unthreading the cartridge.
Insert the Nature 2 cartridge into the opening at the bottom of the
lter cartridge making sure the handle is facing towards the open-
ing (Fig 7). The retention strap should prevent the Nature 2 car-
tridge from falling out of the lter cartridge.
Fig. 7
Reinstall the lter cartridge and then place the oating skimmer
cage over top the cartridge.
5. Streamline Pool Maintenance
Daily:
Test for free chlorine (FC) after you swim, or at least a few times
a week. Add chlorine to maintain FC levels between 0.5 - 1.5
ppm. As you become familiar with the chlorine demand for your
pool, you will nd that you may not have to test for chlorine as
frequently in order to maintain a minimum level of 0.5ppm.
Twice a week:
Check and adjust water level. Water should completely cover
the honeycomb grill where the current is produced. Water 1/2"
(12mm) lower than this can create a choppy current and may
cause your skimmer to draw air into the plumbing lines. Having
the water level 1" (2,5cm) or more higher that honey comb grill
will cause more water to get splashed out of the pool.
11

Other manuals for Endless Pools Streamline

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Endless Pools Streamline and is the answer not in the manual?

Endless Pools Streamline Specifications

General IconGeneral
BrandEndless Pools
ModelStreamline
CategorySwimming Pool
LanguageEnglish

Related product manuals