2. Water Chemistry
Safety Instructions
• Always check for proper sanitizer levels prior to using this product.
• Maintain water chemistry ranges consistent with the ranges presented in these instructions.
• Keep all chemicals out of the reach of children and pets.
• Store all water-balancing chemical in a cool dry place and in their original containers.
• Do not stack balancing chemicals on top of one another.
• NEVER MIX CHEMICALS
• Store sanitizing chemical separately from balancing chemical
Overview
A water chemistry start-up kit, including test kit, has been provided with the StreamLine Pool. This kit should be sufcient to get the pool
properly balanced and ready to swim. Over the course of the pool’s life, additional balancing chemicals will be required. Endless Pools
can only ship these aftermarket chemicals in the continental United States. Ideally, these chemicals will be purchased at any local pool and
spa retail center.
Household bleach, in its most basic form, is the most appropriate form of chlorine for an indoor StreamLine Pool (that is covered when
not in use). If the pool is to be installed outdoors, a more concentrated form of chlorine may be required. This should be discussed with a
local pool and spa professional.
• Recommended chlorine level: .5ppm-1ppm
- Add approximately ¼ cup of household bleach (12%) per day
• Recommended pH range: 7.4-7.6
- To raise pH-Soda Ash (Sodium Carbonate)
- To lower pH-Dry Acid (Sodium Bisulfate)
• Recommended Total Alkalinity (TA) range: 80ppm to 120ppm
- To raise TA-Baking Soda (Sodium Bicarbonate)
- To lower TA-Dry Acid (Sodium Bisulfate)
Detailed Instruction
Source Water
Endless Pools recommends testing a sample of water before you begin to ll the pool. Doing so will give you an idea of how
suitable your water source is for swimming pool use. Testing the water can be done by using your Taylor test kit. A local swimming
pool supply store can also test your water at a minimal charge.
6
To Next Page
Loading...
Need help?
General
