Endless Pools Winterizing Pool Series - Winterizing Endless Pools StreamLine; Turn Off Pool Equipment Power; Drain Pool Water Level; Remove Water from Plumbing Lines

Pool Series & Spa Series Winterizaon Service Instrucon
Endless Pools D90010_en 1122
4
Winterizing Endless Pools StreamLine
1. Turn o power to all pool equipment.
2. Drain approximately 18” of water from the pool.
3. When the water level is below the sucon and return piping, all water MUST be removed from the plumbing
lines. Usually, loosening all union collars is sucient to drain the system. A compressor or wet/dry vacuum may be
necessary to ensure all water is removed.
4. Remove the two drain plugs from the two speed pump housing to remove the water.
5. Add a non-chlorine winter chemical kit to pool water. Kits vary in many ways. The most important characterisc you
should look for is that the kit has a “non-chlorine” oater that will slowly disperse the contents over the course of
the winter. Generally speaking, Endless Pools tend to be much smaller than what the industry would consider a small
pool, so usually the kit labeled for the smallest gallonage will suce. Addional chemicals such as algaecide stain and
scale control, and others may be included with this kit, none of which will damage the equipment but may not be
necessary. Winterizaon kits can be purchased through Endless Pools Customer Service.
6. If outdoors, place a fully inated “exercise ball” in the pool to provide support for the cover while the water level is
lowered for the winter. These can be sourced at your local sporng goods store. Close the retractable security cover
over the exercise ball. Place a cover pump on top and plug into outlet (if outdoors). Be sure that the discharge hose
from the cover pump drains the water away from the pool area. It is a good idea to periodically check the funcon of
the pump and outlet over the course of the winter.