Endless Pools Winterizing Pool Series - Winterizing Endless Pools Spa Series; Legacy Spa Series (2010-2016) Power Off and Drain; Legacy Spa Series (2010-2016) Jet Lines and Plumbing; Legacy Spa Series (2010-2016) Cover Snow Monitoring

Pool Series & Spa Series Winterizaon Service Instrucon
Endless Pools D90010_en 1122
5
Winterizing Endless Pools Spa Series
Refer to the instrucons below for legacy spa series models and the following page for Fitness System models.
Legacy Spa Series Models (shipped between 2010 - 2016)
1. Turn o the circuit breaker or electrical disconnect to the swim spa.
2. Drain the swim spa.
3. If you have an air compressor, remove the drain plug from the jet pump housing, and blow out the jet lines. If you do
not have an air compressor, please proceed to the next step.
4. Disconnect all of the plumbing unions and remove the drain plug from the jet pump housing (you may want to have
a shop vac on-hand to help contain the water that will drain out, especially if the swim spa is indoors).
5. If a bi-fold cover is installed, snow MUST be monitored and removed from the top of the cover to prevent damage.
6. If the swim spa does not have a bifold cover, construct a winter cover:
A. Lay 2x4’s on edge across the width of the swim spa. Space them 16” apart on center.
B. Create a pitch to the cover by laying a 2x4 along one long side of the swim spa on top of the 2x4’s that are
spaced every 16.”
C. Cover these 2x4’s with plywood and cover the plywood with a tarp.