Endress+Hauser Micropilot FMR50 - Page 23

Micropilot FMR50 HART Installation
Endress+Hauser 23
• Align the antenna vertically to the product surface.
Optionally, a variable flange seal, which is available as an accessory, can be used for
alignment (see Technical Information BA01048F, chapter "Accessories").
• A marking at the feedthrough enables alignment of the antenna. This marking must be
aligned towards the tank wall as well as possible.
90°
90°
90°
90°
90°
A0019439
Depending on the device version the marking may be a circle or two short parallel lines.
Nozzle mounting
H
øD
A0016868
 5 Nozzle height and diameter for horn antenna with slip-on flange