Micropilot FMR60/62/67
Endress+Hauser 27
Modification
Modifications are changes to devices with SIL capability already delivered or installed.
‣
Modifications to devices with SIL capability are usually performed in the Endress+Hauser
manufacturing center.
‣
Modifications to devices with SIL capability onsite at the user's plant are possible following
approval by the Endress+Hauser manufacturing center. In this case, the modifications must be
performed and documented by an Endress+Hauser service technician.
‣
Modifications to devices with SIL capability by the user are not permitted.
Decommissioning
When decommissioning, the requirements according to IEC 61508-1:2010 section 7.17 have to be
observed.
To Next Page
Loading...
