Accessories Oxymax COS22
26 Endress+Hauser
11 Accessories
The following are the most important accessories available at the time this
documentation was issued. For accessories not listed here, please contact your service
or sales office.
11.1 Assemblies (selection)
Cleanfit CPA875
• Retractable process assembly for sterile and hygienic applications
• For in-line measurement with standard 12 mm sensors for parameters such as pH, ORP
and oxygen
• Product Configurator on the product page: www.endress.com/cpa875
Technical Information TI01168C
Flowfit CPA240
• pH/redox flow assembly for processes with stringent requirements
• Product Configurator on the product page: www.endress.com/cpa240
Technical Information TI00179C
Unifit CPA442
• Installation assembly for food, biotechnology and pharmaceutics
• With EHEDG and 3A certificate
• Product Configurator on the product page: www.endress.com/cpa442
Technical Information TI00306C
Cleanfit CPA450
• Manual retractable assembly for installing 120 mm sensors in tanks and pipes
• Product Configurator on the product page: www.endress.com/cpa450
Technical Information TI00183C
Flow assembly
• For sensors with Ø 12 mm and length 120 mm
• Compact stainless steel assembly with low sampling volume
• Order No. Order No.: 71042404
11.2 Measuring cable
11.2.1 Cable for COS22
COK21
• Cable length 3 m (9.8 ft)
Order No. 51505870
• Cable length 10 m (33 ft)
Order No. 51505868
11.3 Zero-point gel
COY8
Zero-point gel for oxygen sensors
• Oxygen-depleting gel for test purposes
• Product Configurator on the product page: www.endress.com/coy8
Technical Information TI01244C
To Next Page
Loading...
