Endress+Hauser Tankvision NXA820 - 7.2.4 NXA820 Specific Settings

Tankvision configuration
32
7.2.4 Tank Scanner NXA820 specific settings
Login to the Tank Scanner NXA820 as "Supervisor" and perform the following configurations (for
details refer to BA339F "Tankvision NXA820, NXA821, NXA822 - Description of Instrument
Functions"):
1. Field Scan Configuration
a. In the navigation tree, click the "System" header.
b. Click "Global Settings" (below the "System" header).
c. In the main screen, click the "Field Scan" header.
d. Click the individual headers of the Field Scan menu and configure the parameters
2)
.
For a description of the parameters refer to
– BA339F, Chapter 11.5 (Modbus)
– BA339F, Chapter 11.6 (V1)
– BA339F, Chapter 11.7 (WM550)
2. Tank Configuration
a. In the navigation tree, click the ’Tanks’ header.
b. In the main screen, select the tank you are going to configure and click the "Modify"
button.
c. Click the individual headers of the tanks menu ("General Details", "Capacity Details", ...)
and configure the parameters. For a description of the parameters refer to BA339F/00/EN.
3. Product-tank assignment
a. In the navigation tree, click the "Tanks" header.
b. In the list below the "Tanks" header select a tank.
c. In the main screen click the "Assignment Product" tab (if necessary use the "<<" or ">>"
button to find the "Assign Product" tab.
d. Select the product from the drop-down list.
e. Click "Submit" to save the settings.
!
Note!
For details about tank-product assignment refer to BA339F/00/EN.
4. Additional Settings
Depending on your requirements, you can perform numerous further settings. For details refer
to BA339F.
5. Start Field Scan
a. In the navigation tree, click the "System" header.
b. Click "Global Settings" (below the "System" header).
c. In the main screen, click the "Fiel Scan" header.
d. Click the "Start/Stop Field Scan" tab and then click on "Start". Field Scanning is now active.
2) The parameters can only be edited if the field scan is not currently active. If necessary, go to the ’Start/Stop Field Scan’ tab and stop the field scan.