Tankvision configuration
37
The following parameters have to be checked for the V1 protocol:
• Gauge slave address (DEC) assignment to the tank ID / tank name
• Gauge type assignment to the tank ID / tank name
• V1 map file assignment to the gauge type
Field Scan Configuration - V1 Protocol
The following parameters have to be checked for the WM550 protocol:
•Baud rate
• Loop current
• Gauge slave address assignment to the tank ID / tank name
• Gauge type assignment to the tank ID / tank name
• WM550 map file assignment to the field device type (gauge type)
Field Scan Configuration - WM550 Protocol
To Next Page
Loading...
