Why is login via SmartBlue not possible on my Endress+Hauser Monitor?
If you cannot log in via SmartBlue on your Endress+Hauser Monitor, first enable the Bluetooth function on your smartphone or tablet. If that doesn't work, perform a recovery sequence to enable the Bluetooth function of the sensor. As a last resort, attach the HistoROM.
How to fix key not responding on Endress+Hauser Monitor?
If the keys on your Endress+Hauser Monitor are not responding, it could be due to a dirty cover glass. Remove the dirt and wait 3 minutes for the keys to respond. Condensation may also be the issue, so wipe the glass dry with a clean cloth and wait 3 minutes. Direct sunlight can also interfere, so provide shade. Finally, check if Bluetooth operation is active, indicated by a flashing Bluetooth symbol or crossed-out key symbols.
What to do if Endress+Hauser Monitor cannot be operated via SmartBlue?
If the device cannot be operated via SmartBlue, ensure that you have entered the correct password. If the sensor temperature is too high (over 60 °C or 140 °F) due to ambient temperature, Bluetooth communication may be disabled. Shield, isolate, and cool down the device if necessary.
Why does Endress+Hauser Monitor have wrong key response during rain?
If the keys on your Endress+Hauser Monitor respond incorrectly during rain, it's because raindrops can be misinterpreted as user input. To prevent this, lock the display. Locking activates automatically if the device isn't operated for a while or can be activated manually.
What to do if key is not responding or too sensitive on Endress+Hauser Monitor?
If the keys on your Endress+Hauser Monitor are not responding or are too sensitive after opening the housing cover, the display might be crooked in the housing. Open the housing again and make sure the display is correctly mounted and properly engaged in the catches.
Why Endress+Hauser Monitor is visible but not accessible via SmartBlue?
If your Endress+Hauser Monitor is visible in the live list but cannot be accessed via SmartBlue on an Android device, ensure the location function is permitted for the app and was approved initially. For certain Android versions, GPS or the positioning function must be activated with Bluetooth. Activate GPS, fully close and restart the app, and enable the positioning function for the app.
Why is my Endress+Hauser Monitor visible but not accessible via SmartBlue on Apple device?
If your Endress+Hauser Monitor is visible in the live list but cannot be accessed via SmartBlue on an Apple device, log in as a standard user. Enter the username "admin" and the initial password (device serial number), paying attention to upper and lower case.
Why key is not responding after housing cover cleaning on Endress+Hauser Monitor?
If the keys on your Endress+Hauser Monitor are not responding after cleaning the housing cover, it is because the cleaning changes the reflection properties of the device cover. The function readjusts automatically; operation should be possible again after approximately 3 minutes.
Why are the keys not responding when operating Endress+Hauser Monitor with gloves?
If the keys on your Endress+Hauser Monitor are not responding when operating with gloves, it may be because the glove reflection is too low to detect operation, especially with black gloves. Remove the gloves or replace them with gloves made of a different material.
General| Brand | Endress+Hauser |
|---|---|
| Model | VU113 |
| Category | Monitor |
| Language | English |
To Next Page
