Leveling The Treadmill
Leveler Legs
After finding a location that is suitable for the treadmill, the
rear legs may need to be adjusted to provide stable support.
Turn the adjustable leg counter clockwise to raise the height
(Fig. 1). Once you have reach the desired leg height for
leveling, lock the leg in place by hand tightening the collar
to the frame (Fig.2).
WARNING:
DO NOT adjust legs while the treadmill is on. Turn the power switch to the OFF position.
While kneeling behind the treadmill, place the heal of your hands on each side of the
treadmill directly above the running-belt adjustment bolts. Attempt to rock the treadmill
by alternately pressing downward on each side. If you feel even a slight movement on
one side adjust that side until the movement has stopped.
For example, if you feel a slight rocking on the right side, start by turning the
thumb-wheel on the right leg counter-clockwise to lower the leg until the
movement stops.
Treadmill Overview
POWER SWITCH
The power switch is located in the front of the treadmill near the power cord.
The power switch has two positions - ON and OFF. The display console will
beep when the treadmill is plugged in and the power switch is pressed ON.
CIRCUIT BREAKER RESET
The circuit breaker is located next to the power switch. If there should be an electrical
overload due to a surge in electricity or other situation, the circuit
breaker will disconnect
and attempt to prevent any damage
from occurring to the treadmill. If the treadmill suddenly stops
with no lights visible nor beep heard, the circuit breaker may
need to be reset. To reset the circuit breaker press the button
firmly. The display console should restart and a beep should
be heard.
POWER CORD
The power cord, located in the front of the treadmill must be plugged into a properly
grounded electrical outlet. Locate the power cord so it will not come in contact with the
wheels of the treadmill during operation. This may cause the power cord to become
pinched or damaged. Damage to the power cord could result in a fire hazard or cause
personal injury through electrical shock.
CAUTION:
Feel the power cord with your hands. If the power cord is warm to the touch a problem
may exist with the electrical outlet in which the treadmill is plugged. It may be
necessary to plug the treadmill into a different outlet.
Fig. 1 Fig. 2
15
To Next Page
