24/44
9. TROUBLESHOOTING
The charger can be repaired by qualified personnel only. Please contact your dealer to receive
the technician’s manual.
9.1. Warning signals
If the device issues a warning, the top RED LED will start flashing.
Cases in which the warning LED starts flashing: manual stop,
manual push of the EQ button, AC input frequency is out of
range, …
1. Manual stop
If the RED LED flashes and the RGB LED has a fixed GREEN
colour, this means that the charging or EQ programme has been
manually interrupted by the user. This was done by pressing the
STOP button.
If you press the STOP button again, the charger will restart the
cycle from the point of interruption.
2. Manual equalize
If the RED LED is flashing and the RGB LED is flashing RED or GREEN, it means that the user has
requested an immediate EQ cycle after the standard charge cycle has been completed.
The charger will perform a standard cycle, and at the end of the cycle charger will immediately apply
the EQ cycle, instead of waiting for the set delay.
To Next Page
Loading...
