What does overdischarge mean on Energic Plus Battery Charger?
If the Energic Plus Battery Charger indicates overdischarge, it means the battery is over-discharged. Your battery needs to be regenerated. Please contact your dealer.
What to do if Energic Plus Battery Charger displays overcurrent?
If the Energic Plus Battery Charger is showing an overcurrent error, it means there is an abnormal input current recording. The charger will automatically restart after 3 seconds. If the problem persists, contact your dealer.
What to do if Energic Plus Battery Charger says there is a problem with the battery?
If the Energic Plus Battery Charger indicates a problem with the battery, it could be due to the battery being disconnected or not conforming with the high frequency charger. First, verify the connection. If the connection is correct, check the nominal voltage of your battery and see if it is compatible with the high frequency charger.
What to do if Energic Plus Battery Charger says there is a problem with the thermal sensor?
If the Energic Plus Battery Charger indicates a problem with the thermal sensor, it might be disconnected during the recharge or out of range. Verify the connection of the sensor. If the connection is correct, measure the temperature of the battery.
What to do if Energic Plus Battery Charger says unavailable configuration has been selected?
If the Energic Plus Battery Charger indicates that an unavailable configuration has been selected, it means that an unavailable configuration has been selected. Check and adjust the selected configuration.
What does EEPROM ko mean on Energic Plus Battery Charger?
If the Energic Plus Battery Charger displays 'EEPROM ko', it indicates a problem has occurred in the EEPROM communication. Turn the high frequency charger off, wait 5 seconds, and turn the charger back on. If the problem persists, contact your dealer.
What does node reset mean on Energic Plus Battery Charger?
If the Energic Plus Battery Charger displays a node reset, it means the CAN Node has been set to 126, which is the reset value. The high frequency charger will force you to enter the ‘Changing settings’ again.
What to do if Energic Plus Battery Charger says phase 1 and/or phase 2 shall have a duration in excess of the maximum permitted duration?
If the Energic Plus Battery Charger indicates that Phase 1 and/or phase 2 shall have a duration in excess of the maximum permitted duration, it means the battery is not compatible with the high frequency charger. Verify the battery capacity.
What does mismatch voltage mean on Energic Plus Battery Charger?
If the Energic Plus Battery Charger displays a mismatch voltage error, it indicates problems in the voltage circuit. Turn the high frequency charger off, wait 5 seconds, and turn it back on. If the problem continues, contact your dealer.
What does timeout mean on Energic Plus Battery Charger?
If the Energic Plus Battery Charger displays a timeout error, it means the first phase has ended due to a time-out. Check if the high frequency charger is suitable for the specified battery type and disconnect the battery.
General| Brand | Energic Plus |
|---|---|
| Model | NG3 |
| Category | Battery Charger |
| Language | English |
To Next Page
