Accel CS Boiler - Gas Heat - Eighth Edition – January, 2015 4
RECORD OF INSTALLATION
All installations must be made in accordance with all State and Local Codes, which may differ from this manual and in
accordance with the following Codes, as applicable:
National Fuel Gas Code, ANSI Z223.1/NFPA 54:
Installation Codes, CAN/CGA B149
National Electrical Code, ANSI/NFPA 70
Canadian Electrical Code Part I, CSA 22.1, Electrical Code
Chimneys, Fireplaces, Vents and Solid Fuel Burning Appliances, ANSI/NFPA 211
Where required by the authority having jurisdiction, the installation must conform to the Standard for:
ANSI/ASME CSD-1 Controls and Safety Devices for Automatically Fired Boilers
These codes are available from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269-9101.
A hot water boiler installed above radiation level or as required by the Authority having jurisdiction, must be provided with a
low water cutoff device.
Make sure relief discharge pipes from all reliefs are properly placed to safely contain discharge. Make sure relief discharge
pipes, such as from a boiler or a hot water storage tank, will safely contain hot water and/or boiling water. Make sure relief
discharge pipes, such as from a boiler or a radiant heating system, will safely contain water treated with boiler chemicals
and/or antifreeze. Reliefs include the boiler pressure relief valve, the back flow preventer discharge port, and the domestic
hot water tank temperature and pressure relief valve. Any other reliefs, such as from radiant heating systems, must also
follow these guidelines.
To Next Page
Loading...
Need help?
General
