94
The hardware contains moving parts (e.g. blowers, the
motor and the belt of the rotating heat exchanger) that
wear down in use. Because of normal wearing, these
parts must be changed during the hardware lifetime. The
normal lifetime of wear parts is dened by the operating
conditions and periods, which means that a normal
maintenance period cannot dened for the wear parts.
Maintenance notication
Control panel reminds about the performing of regular
maintenance actions.
MAINTENANCE
The ventilation unit uses 5 plain and F7 bag lters.
The unit does not need much maintenance. Sucient
maintenance usually covers the following tasks:
• changing lters
• cleaning the heat exchanger (when sweeping the
ventilation ductwork)
• cleaning the lters (when sweeping the ventilation
ductwork)
• checking the condensation water removal pipe.
Before starting maintenance, switch o the power
by removing the plug from the socket. Wait
approximately two (2) minutes before starting
maintenance. Although power has been shut
down, the blowers will rotate and the electric coil
will be hot for a while.
DANGER
When some part of the hardware is maintained,
check if the other parts are clean or worn.
For more information on maintenance actions, see
a video in the Help Center on our website at www.
enervent.com.
NOTE
Filters
supply lter F7
extract lter M5
Vacuuming/cleaning of the M5 plain and F7 bag
lters is not allowed.
NOTE
Filter type Service interval
Plain lter 4 months
Bag lter 6 months
To Next Page
Loading...
