ENFORCER Piezoelectric Mullion-Style Outdoor Stand-Alone Keypads
SECO-LARM U.S.A., Inc 11 SECO-LARM U.S.A., Inc. 33 11
1. Enter a user ID number ( to ). The LED will turn green.
2. If the LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the LED will turn green.
3. Swipe a new user card. The keypad will sound 1 short and 1 long beep and the LED will remain green.
4. Return to Programming Mode by pressing .
NOTE: Must return to Programming Mode after learning a card, otherwise user will overwrite existing card.
5. To program the next user, repeat from step 1 in section A, B, or C.
6. Exit Programming Mode by pressing again.
1. Enter a user ID number ( to ). The LED will turn green.
2. If the LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the LED will turn green.
3. Enter a new user code. The keypad will sound 2 short beeps and the LED will turn yellow.
4. To program the next user, repeat from step 1 in section A, B, or C.
5. Exit Programming Mode by pressing .
1. Enter Programming Mode by entering the Master Code twice. The LED will turn yellow.
2. Enter . The LED will flash yellow.
3. Enter one of the following:
User card ONLY
Either user card OR user code (DEFAULT)
User card AND user code
The keypad will sound 2 short beeps and the LED will turn yellow.
NOTE: Deleting all users is recommended before changing the access mode to user card AND user code.
See pg. 14, Deleting All Users.
4. Exit Programming Mode by pressing .
1. Enter Programming Mode by entering the Master Code twice. The LED will turn yellow.
(Default Master Code is 1234)
2. Enter . The LED will flash green.
3. If the LED is solid green, a Master Card is already programmed. Clear it by entering .
The keypad will sound 2 short beeps in confirmation and the LED will start flashing green.
4. Swipe a proximity card (PR-K1S1A or similar). The keypad will sound 2 short beeps and the LED will
turn yellow. This card is now the Master Card.
5. Exit Programming Mode by pressing .
E. Setting the Output #1 Access Mode*
DEFAULT: User card OR user code.
Each Output #1 user can be programmed to have a user code, a user card, or both a user code and card.*
A. Programming User Codes
NOTE: For all of the following programming functions, the keypad must be in Programming Mode. To enter
Programming Mode, enter the Master Code twice or swipe the Master Card.
D. Program the Master Card (SK-2323-SPAQ only)
In addition to a Master Code, a Master Card can also be programmed. Swiping a Master Card will give
direct access to Programming Mode.
B. Programming User Cards*
To Next Page
Loading...
Need help?
General
