ENFORCER SK-2323-SDAQ User Manual

ENFORCER Piezoelectric Mullion-Style Outdoor Stand-Alone Keypads
16 SECO-LARM U.S.A., Inc.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
Operation Function
Step 1
Step 2
Step 3
Change the master code
Enter
Enter the new Master
Code twice
Program a new Output #1
user code
Enter a 3-digit
user ID
(from 000~999)
Enter a user code.
Program a new Output #2
user code*
Enter 4
Enter a 2-digit user ID
(from 00~09)
Enter a new user
code.
Deleting an Output #1 user *
Enter a 3-digit
user ID
(from 000~999)
Enter
Deleting an Output #2 user *
Enter 4
Enter a 2-digit user ID
(from 00~09)
Enter
Set Output #1 timer
Enter 1
Enter number of seconds
(from 00~99)
Set Output #2 timer
Enter 5
Enter number of seconds
(from 00~99)
Set Output #2 function
Enter 2
Enter: 01 for user codes
02 for doorbell
Set tamper alarm
Enter 6
Enter: 01 for OFF
02 for ON
Quick Reference Guide
Operation Function
Action
Enter an Output #1 user code
Directly enter on the keypad
Enter an Output #2 user code
Directly enter on the keypad
Ring doorbell
Press (if programmed)
Enter Programming Mode
Enter the master code twice
Exit Programming Mode
Press
Reset or restore the keypad
Please see full instructions on pg. 14
Program the proximity card reader
Please see full instructions on pgs. 10 to 13
The following functions are performed after entering Programming Mode.
*After programming these functions, press to return to Programming Mode.
NOTE: For complete programming instructions, please see pg. 10, Programming Instructions.
#
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800
Email: sales@seco-larm.com
®
PICCN2
MI_SK-2323-SxAQ_171023.docx
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2017 SECO-LARM U.S.A., Inc. All
rights reserved.

ENFORCER SK-2323-SDAQ Specifications

General

Brand	ENFORCER
Model	SK-2323-SDAQ
Category	Keypad
Language	English