EnGenius ECB300 Quick Installation Guide

Quick Installation Guide
ECB300 802.11b/g/n Wireless Client Bridge
Please verify contents of the box before continuing to set up the ECB300.
 ECB300 * 1
 12V/1A 100V~240V Power Adaptor * 1
 RJ-45 Ethernet Cable * 1
 Detachable Antenna * 2
 CD with User's Manual * 1
 Quick Installation Guide * 1
Hardware Installation
1) Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more information,
verify with User Manual.
2) Connect one end of the Category 5e Ethernet cable into RJ-45 port of the ECB300 and the other
end to the RJ-45 port on the computer that will use the ECB300. Ensure that the cable is securely
connected to both the ECB300 and the Computer.
3) Connect the Power Adaptor DC Inlet to the DC-IN port of the ECB300 and the Power Adaptor to
the electrical out.
IP address configuration
1) After ensuring the EnGenius device is powered on and plugged in, ensure that your computer is
on.
2) For the next steps, refer to your Operating System User Manual.
3) Once your computer is on, ensure that your TCP/IP is set to On or Enabled. (In the control panel,
double click Network Connections and then double click on the connection of your Network
Interface Card (NIC). Select Internet Protocol (TCP/IP) and then click on the Properties button.)
4) If your PC is already on a computer network, ensure that you have set it to a Static IP Address on
the interface (or Ethernet card that will use the ECB300) as 192.168.1.21 and the Subnet Mask
6709A0213740

EnGenius ECB300 Specifications

General

5 GHz	No
Modulation	16-QAM, 64-QAM, BPSK, CCK, DBPSK, DQPSK, QPSK
Frequency band	2.4 - 2.484 GHz
Operating modes	Access Point (AP), Client Bridge, Repeater, Router, WDS Access Point (AP), WDS Bridge
Channel bandwidth	40 MHz
Channels quantity	11 channels
Transmitting power	19 dBmW
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3af
Virtual LAN features	Tagged VLAN
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Quality of Service (QoS) support	Yes
Antenna features	Detachable antenna
Antennas quantity	2
Antenna connector type	SMA
Antenna gain level (max)	5 dBi
Placement	Table
Certification	FCC, CE, IC
Product color	Black, Grey
WAN connection	Ethernet (RJ-45)
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
VPN support	IPsec, L2TP, PPTP
Security algorithms	128-bit WEP, 64-bit WEP, WPA-AES, WPA-PSK, WPA-TKIP, 802.1x RADIUS
Number of SSID supported	4
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
AC input voltage	90 - 240 V
AC input frequency	50 - 60 Hz
Power requirements	12V/1A DC
Cables included	LAN (RJ-45)
Flash memory	4 MB
Internal memory	32 MB

Weight and Dimensions

Depth	135 mm
Width	105 mm
Height	30 mm
Weight	280 g
Dimensions (WxDxH)	105 x 135 x 30 mm