Need help?Do you have a question about the EnGenius ECB350 and is the answer not in the manual?
General| Frequency band | 2.4 - 2.484 GHz |
|---|---|
| Channels quantity | 11 channels |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1Q, IEEE 802.3af |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Maximum data transfer rate | 300 Mbit/s |
| Quality of Service (QoS) support | Yes |
| Antenna features | Detachable antenna |
| Antennas quantity | 2 |
| Antenna connector type | SMA |
| Antenna gain level (max) | 5 dBi |
| Internal | No |
| Certification | FCC, CE, IC |
| WAN connection | Ethernet (RJ-45) |
| Security algorithms | 128-bit WEP, 64-bit WEP, SSID, WPA-AES, WPA-EAP, WPA-PSK, WPA-TKIP |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Power requirements | 12V / 1A |
| Flash memory | 8 MB |
| Internal memory | 32 MB |
Weight and Dimensions| Weight | 280 g |
|---|---|
| Dimensions (WxDxH) | 105 x 135 x 30 mm |
Explains the physical connection of the ECB350 to power and computer.
Guides users through accessing and logging into the web-based configuration interface.
Allows selection and configuration of the device's primary operating mode.
Enables modification of the device's IP address, subnet mask, and gateway.
Configures Wide Area Network connection types: Static IP, DHCP, PPPoE, PPTP.
Details how to configure a static IP address for WAN internet connection.
Explains configuration for WAN connection using DHCP for automatic IP assignment.
Guides through PPPoE configuration for DSL internet connections.
Details PPTP configuration for Point-to-Point Tunneling Protocol WAN connections.
Allows configuration of the device's Local Area Network settings, including DHCP server.
Configures basic wireless network settings like SSID, channel, and mode.
Configures security settings like WEP, WPA-PSK, WPA2-PSK for the wireless network.
Manages system password, remote access, and firmware upgrades.
Guides users through the process of upgrading the device's firmware.
Explains how to reboot the device or restore it to factory default settings.
Explains how to use the ECB350 as a client bridge to connect to an Access Point.
Describes using the ECB350 as a central wireless access point for clients.
To Next Page
