EnGenius ECB600 - Page 3

ECB600
Dual Band Long Range Multi-Function Access Point/ Client Bridge
2.4GHz+5GHz 300Mbps+300Mbps 29dBm AP/CB/WDS/Repeater
L2 Isolation
Supported
LAN Settings
IP (check validity)
VLAN
MSSID
VLAN tag on MSSID
Management VLAN
Ethernet Port VID
Only allow user with specified VID to access the device
Tag/ Untag Option
Independent VLAN setting can be enable or disable
Add VLAN tag
Any packet that enters the Device without a VLAN tag will have a VLAN
tag inserted with a PVID (Ethernet Port VID)
VLAN Pass through
VLAN pass through over WDS bridge
SNMP
SNMP V1/V2C
- SNMP Active : Disabled / Enabled
- SNMP Version : V1/V2c/ALL
- Read Community
- Set Community
- System Location
- System Contract
- Trap Active : Disabled / Enabled
- Trap Manager IP
MIBI, MIBII
Private MIB
SNMPv3
QoS
WMM (Default)
Load Balance Per SSID
Administration
User Name (set as “admin”, can be changed by user)
Password (c set as “admin”, can be changed by user)
Backup/ Restore Setting
Save Current Setting
Restore Saved Setting
Reset to Factory Default
Firmware Upgrade
supported
UPnP
Supported
Firmware Upgrade
supported
Advanced Management
Auto Reboot
CLI
NMS (EZ Controller) supported
Hardware Specifications
MCU
AR9344+AR9382
Memory/ Flash
64MB / 16MB