Need help?Do you have a question about the EnGenius X-TRA RANGE ERB300H and is the answer not in the manual?
General| Model | ERB300H |
|---|---|
| Type | Wireless Access Point |
| Wireless Standards | IEEE 802.11b/g/n |
| Frequency Band | 2.4 GHz |
| Maximum Data Rate | 300 Mbps |
| Humidity | 10% to 90% non-condensing |
| Antenna | 2 x 5 dBi |
| Power over Ethernet (PoE) | Yes |
| Operating Modes | Access Point, WDS AP, WDS Bridge |
| Security | WEP, WPA, WPA2 |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
Introduces the EnGenius ERB300H/ERB150H, highlighting its wireless integration and ease of use.
Details the three operating modes: Repeater, Client Bridge (CB), and Client Router (CR).
Lists key hardware specifications such as wireless speed, antenna connectors, and Wi-Fi standards.
Outlines software features including system log, client list, signal indicator, and channel settings.
Lists the necessary hardware and software prerequisites for installing the ERB300H/ERB150H.
Guides users through the initial software installation process for the device.
Explains the procedure for connecting the power adapter and network cables to the device.
Introduces the setup process for the device as a Range Extender or Media Bridge.
Provides instructions for using the device to extend wireless network coverage.
Explains how to use the device to wirelessly connect home entertainment devices.
Guides connecting the device to an existing wireless network via WPS or Smart Wizard.
Details the steps for configuring the device using the Smart Wizard, including login credentials.
Explains how to access the device's web interface by entering username and password.
Explains device functionality in Universal Repeater, Client Bridge, and Client Router modes.
Details how to set the primary function: Universal Repeater, Client Bridge, or Client Router.
Explains how to view and configure DHCP addresses, including the DHCP Client Table.
Guides on defining device mode, signal band, and connecting to multiple ESSIDs.
Guides on configuring WPA and WPA2 security settings with a pre-shared key.
Details WPA/WPA2 security configuration for AP profiles.
Guides on configuring LAN settings using static or dynamic IP addresses.
Explains how to enable/disable the DHCP server and configure its settings.
Details how to configure WAN settings for static IP connections.
Guides on enabling or disabling the firewall for network protection.
Explains how to configure a DMZ host for unrestricted internet access.
Details how to enable or disable blocking of Denial of Service (DoS) attacks.
Explains how to enable or disable Network Address Translation (NAT) for internet access.
Guides on redirecting service port numbers from WAN to a specific LAN IP address.
Details how to forward ports for multiple server applications on the LAN.
Explains how to map application ports to a specific public port for triggering.
Describes Quality of Service (QoS) for prioritizing network traffic.
Explains how to set up static routes for network connectivity under different subnets.
Guides on changing system password, system name, and idle timeout value.
Guides on upgrading the device's firmware through an approved web site.
Details how to set the system time, including synchronization with NTP servers.
Explains how to diagnose network connection problems by pinging devices.
To Next Page
