14
(km/h) and the trip distance (km) by default. By pressing the button , the
information displayed will be switched between the trip distance (km), ODO
(km), maximum speed (km/h) and average speed (km/h).
When the distance reaches 9999.9 km, it will be automatically reset to
zero.
5.3 Push assistance
By pressing and holding the button , the electric push assistance
mode will be enabled. Your e-bike will run at the constant speed of 6km/h.
The display will show level P. By releasing the button , your e-bike will
immediately stop power output and return to the state before push
assistance.
■ The push assistance function can only be used when you are pushing your
e-bike. Please do not use it during riding.
5.4 Headlight on/off
By pressing and holding the button , the controller will turn on the
headlights and the display backlight will turn dark. By pressing and holding
the button again, the controller will turn off the headlights and the display
backlight will resumes the luminance.
5.5 Assist level selection
By pressing the button / , the e-bike assist level will be switched to
change the motor output power. The assist levels available for the display
include: levels 1-5.
5.6 Battery level indicator
The battery level indicator consists of five segments. When the battery is
fully charged, the five segments will be all on. In case of low voltage, the
outline of the battery indicator will flash, which means the battery has to be
To Next Page
Loading...
