Enko AMF 3.1 - Interface Structure

14/22
AMF 3.1 USER MANUAL
F34,F35,F42
F43,F45
Feedback Alarm, GCB Feedback Alarm, Thermic Alarms can be auto-
acknowledged. Parameter P221 is inactive in an Earthquake or
Emergency situation.
F16,F17,F21
F31,F32,F33
F34,F35,F42
F43,F45
Depends on the function assigned to Aux. Input 4. Oil Switch, High
Temperature Switch, Low Coolant Level, Aux. Alarm 1-2-3-4-5, MCB
Feedback Alarm, GCB Feedback Alarm, Thermic Alarms can be auto-
acknowledged. Parameter P227 is inactive in an Earthquake or
Emergency situation.
P227
F16,F17,F21
F31,F32,F33
F34,F35,F42
F43,F45
Depends on the function assigned to Aux. Input 5. Oil Switch, High
Temperature Switch, Low Coolant Level, Aux. Alarm 1-2-3-4-5, MCB
Feedback Alarm, GCB Feedback Alarm, Thermic Alarms can be auto-
acknowledged. Parameter P233 is inactive in an Earthquake or
Emergency situation.
P233
F16,F17,F21
F31,F32,F33
F34,F35,F42
F43,F45
Depends on the function assigned to Aux. Input 6. Oil Switch, High
Temperature Switch, Low Coolant Level, Aux. Alarm 1-2-3-4-5, MCB
Feedback Alarm, GCB Feedback Alarm, Thermic Alarms can be auto-
acknowledged. Parameter P239 is inactive in an Earthquake or
Emergency situation.
P239
F24
Overcurrent Alarm
P273
F26
High KW Alarm
P278
F28
High KVar Alarm
P283
F29
Power Factor Alarm
P288
F27
High KVA Alarm
P293
F54
Reverse Power Alarm
P298
Interface Structure
On the running screen of the unit, the measured values are shown. The operator can navigate through various
measurements bu using the up or down buttons.
Screen
Definitions
Descriptions
1
st
Row: VR-N Voltage.
2
nd
Row: Blank
While on this screen, pressing the up
button will navigate to the screen shown
below.
While on this screen, pressing the down
button will navigate to the screen shown on
the bottom of this table (Fuel Level).
1
st
Row: VS-N Voltage.
2
nd
Row: Blank
Please see Note 1.