The alarm log screen is the 2
nd
page that appears in the menu and can be navigated by pressing the Up and
Down buttons, and pressing the Menu button on the “P2 ALr” screen. The alarm log screen displays the code,
date and stamp for the last 15 alarms in the system. After entering the menu, the screen below appears.
The alarms are listed on this page and the sorting is as last alarm occured - displayed first, and the previous
alarms are listed below that. The operator can scroll through the alarms by using the Up and Down buttons.
The code of the alarm is displayed here.
The screen on the left indicates that the alarm occured is F17 “High Coolant Temperature”. The running hour
time stamp information can be seen by pressing the Down button. The screen similar to the one shown below
will appear.
The total running hours when the at the time the alarm occurred is displayed on this screen. The alarm code
screen displayed above can be reached by pressing the Up button.
P3-Maintenance Timers Screen
The maintenance timers screen is the 3
rd
page that appears in the menu and can be navigated by pressing
the Up and Down buttons, and pressing the Menu button on the “P3 SEr” screen. There are 4 timer groups
which are: General Maintenance Timer, Engine Maintenance Timer, Total Engine Running Hours, Total
System Running Hours. The desired timer can be navigated using the Up and Down buttons.
The first timer is the General Maintenance Timer and is indicated as “gEn” as seen on the screen on the left.
A few seconds after this indication the second screen seen on the left will appear. The screen indicates that
To Next Page
Loading...